| How To Safely Haul Your Classic Car |
9 Apr |
Begin by looking at your trailer. Is there sufficient length for the Classic Car plus enough space to operate the ratchet assemblies at the fore and aft of the bodywork? Do you have D rings located towards the corners of the trailer? Is the D ring rated for a total of 3 times the weight of the car? Once these items have been addressed, It is time to load the car and tie it down.
Once you have loaded it onto the trailer, the next step is to connect the straps. You can buy a complete tie down kit from Macs custom tie downs. Start by connecting the twisted snap hook on the fixed end (the short end) to each of the D rings. Choose a set of locations to tie down to.
Typically, on a Classic Car those locations would be through the wheel, over an axle or substantial suspension member, or possibly around a frame horn.
Some general guidelines to keep in mind are: choose a location with enough strength to hold the Classic Car in the event of an accident, one that is free of cutting hazards, and with enough space around it to lace the axle strap.
DO NOT run a strap where it might migrate and crush a brake line. Also consider the effect of the movement of the Classic Car while it is traveling down the road, since what may seem like a clear space now, could become tie down strap guillotine later, if the trailer hits a hard bump.
After choosing a location, you should now run your axle strap around it. Check the length if the standard 24 isnt enough, dont worry Macs can make the strap in any length needed in a short timeframe.
After determining that the length is correct, align the two delta rings at the end of the axle strap together and click in the running end (long end) of the ratchet strap. Before ratcheting the strap tight, pull the tail end of the strap through until the strap looks straight. Now you can ratchet the strap, making sure to have two full wraps around the mandrel to ensure a positive mechanical lock. Repeat this process at all four corners of the Classic Car.
Should you cross the straps? Possibly. Understand that the strap will have its maximum strength in the line it is pulling. It is always a good idea to have the straps at the rear of the Classic Car pulling mostly straight back. Most vehicles will out corner a trailer, so the Classic Car is more likely to come loose when an accident occurs than wander around when properly tied down. Be sure to take a look at the setup in your trailer and make sure that it is sensible this is the best test for tie downs.
Tags: Bodywork, Bump, Clas, Classic Car, Custom Tie, Delta, Enough Space, Four Corners, Guillotine, Lace, Macs Custom Tie Downs, Mandrel, Snap Hook, Tie Down Kit, Timeframe, Wheel, WrapsRelated posts
read comments (0)| A Car Needs New Upholstery Too |
28 Nov |
Upholstery refers to the work done so as to provide seats of your vehicle with padding, springs, webbing, fabric covers, or leather covers. It actually comes from the Middle English words of up and holden. When put together, these words mean to hold up.
When you purchased your vehicle, you surely have noticed that it already came with upholstery. There was nothing you can do with it but to drive around in it and relax. However, time really does bear its mark. Your cars upholstery would have either started to crumble or you would have had to feel each bump and pothole your car runs over for the comfort and relaxing feel of your car seats have gone and said goodbye. When this happens, it simply means that it is the right time to do some reupholstering. And automobile experts say that reupholstering your cars interior is one of the ways to make your machine look like you just bought it from the car dealer.
To have your vehicle reupholstered, start by finding the right shop to do that kind of service. You can ask your car dealer to recommend good upholstery shops. You can also ask car audio specialty shops. Or, you can ask around and ask car owners. Sometimes, the best way to find a good upholstery shop is to go to those that have been recommended by car owners.
When you have a list of upholstery shops in hand, call them and find out about what kind of upholstery they offer. That way, you can check out if they have the right kind of service that you would like your vehicle to receive. Also, ask around for prices and see if it fits your budget.
Once you have chosen your shop, visit it and see what materials they have in stock. That way, you would know your options and your choices. You would be also able to check which materials could work best for your cars interior. With one of the upholstery shops personnel, discuss your budget. Ask his or her help regarding the amount you are willing to pay and the kind of work that your car could receive in exchange. The cost of materials for upholstery could actually range from $6 a yard to a whopping $75.
These shops also have some photographs of the work they have already done. You can request the shops personnel for them. That way, you can see what kind you would like your vehicle to have. You should also ask the personnel to explain to you the process of reupholstering your car.
While at it, you can also choose to spruce up your vehicle. Carpets, grilles, and fenders are available at Auto Parts Go at low prices. They specialize in Nissan parts and they also do offer auto parts for various vehicle models and makes as well.
Tags: Automobile Experts, Budget, Bump, Car Audio, Car Dealer, Car Owners, Car Seats, Car Upholstery, Cars, Choices, Fabric, Holden, Middle English Words, New Upholstery, Pothole, Right Time, Specialty Shops, Stock, Upholstery Shop, Upholstery ShopsRelated posts
